Rapid Building Systems

Rapid Plasters · Mining & Civil

Engineered for the harshest environments.

Rapid Mining Plasters are sprayed gypsum formulations delivered for the harshest environments — hermetically sealed, explosion-proof solutions built around three commitments: safety, rapid deployment, and cost-effectiveness. Engineered to avoid dangerous respirable silica levels, and to reach the locations others can’t.

30+ yrsProven in Australian underground coal mining
>32 MPaPremium high-strength mining plaster
Full-scaleBlast tested — validated for explosion-rated VCD applications
<5%Typical absorption — premium water-resistant grade

The short answer

Why engineered gypsum for mining & civil?

Because underground work rewards materials that are simple to move, easy to prepare, fast to place and rapid to perform.

Rapid Mining Plasters are supplied as dry material, mixed with water at the point of use and spray-applied where needed — a practical solution where access, underground logistics, installation speed and downtime matter.

With >32 MPa compressive strength, high water resistance and rapid strength development, the technology is backed by more than 30 years in Australian underground coal mining and full-scale explosion testing for rated VCD applications. The published testing confirms the rapid strength gain of mining plaster and its use in engineered, explosion-rated gypsum plaster seals.

A miner standing in a hard-rock underground tunnel, headlamp lit.
Underground work rewards simple, fast, dependable materials.

The commercial proposition

Simpler logistics. Rapid application. Proven performance.

Why gypsum?

Easier underground logistics, rapid application.

Dry-supplied, mixed with water at the point of use, spray-applied where needed — no heavy pre-mixed haulage, no waiting on plant.

Why Rapid Plasters?

Strength, water resistance, decades underground.

>32 MPa premium grades with high water resistance — proven across more than 30 years in Australian underground coal mining.

Why trust it?

Full-scale engineering validation.

Real seals, real explosions, published results — testing used to validate engineering design models.

An operator spray-applying gypsum plaster to an underground wall with dustless pump equipment.
Spray application with dustless pump equipment — mixed at the point of use, placed where the work is.
A drift runner vehicle moving through an underground coal roadway.
Underground coal roadways — where rated ventilation control does its work.

Proven in VCD applications

Blast-tested. Engineered. Rated.

Gypsum plaster systems have been full-scale blast tested and engineered for rated underground ventilation control applications. The published program tested real seals under natural-gas explosions, with results used to validate engineering design models.

ENGINEERED GYPSUM — a non-hazardous, mineral-based formulation developed for demanding underground use.

Sprayed solutions

Safety, applied at the speed of the shift.

The harshest environments do not forgive weak materials or slow methods. Our sprayed gypsum formulations build hermetically sealed, explosion-proof solutions fast — engineered to avoid dangerous respirable silica levels, and delivered with conventional spray equipment to the difficult-to-reach locations where the work actually is.

Three commitments govern every formulation: safety for the people who apply it and the people who work behind it, rapid deployment so operations keep moving, and cost-effectiveness proven over several decades across underground coal and hard-rock operations.

A miner spray-applying high-strength water-resistant gypsum to strata underground.
Sprayed application underground — high-strength, water-resistant gypsum supporting strata, applied at the face. RBS site footage.
A worker spray-applying Rapidseal to the face of a self-heating stockpile. Thermal camera view of the same stockpile face: the treated zone reads cool blue while untreated material above still shows hotspots up to 43 degrees.
The same face, two cameras — RapidSeal at work on a self-heating stockpile. FLIR SITE IMAGERY.

Seen in infrared

The treated zone holds cool.

On a self-heating stockpile, the thermal camera tells the story: the RapidSeal-treated face runs cool while untreated material above still heats — protection you can photograph.

RapidSeal seals against both heat and gas — engineered for spontaneous-combustion ("sponcom") control in above-ground pits and stockpiles, and in underground workings alike. PFAS-free, mineral-based protection.

Our position

“When Australian mines build the walls that steer their air, they overwhelmingly build them with our plaster.”
Rapid Building Systems — mining services

Market leadership in a safety-critical product is not a boast; it is a responsibility. It means our quality control answers to every shift underground, our research programme keeps running decades after the first approval, and our supply holds steady because underground operations cannot wait. We hold that responsibility gladly — the dignity of the people who mine demands nothing less.

The full mining offer

One mineral, three jobs underground and above it.

Australian Made and Owned certification logo.

Australian made & owned

Quality you trust. Supply on demand.

The only thing more consistent than the quality of our plaster is our team's commitment to keeping you supplied. Big orders or small, we're ready when you are.

No waiting for material to arrive from overseas — or from the other side of the country.

Questions the industry asks

Mining plaster, plainly answered.

The material

Isn't gypsum a weak material?

Household gypsum is. Engineered gypsum is not: Rapid Mining Plasters deliver more than 32 MPa — a strength grade specified for structural concrete — with explosion-proof approval and the highest water resistance in their class, developed and held in wet working conditions.

Silica

What about respirable silica?

Our formulations are engineered to avoid dangerous respirable silica levels — protecting the crews who apply them as well as the people who work behind them.

Placement

How is it placed underground?

With conventional spray and pump equipment. It reaches strength quickly, so protection goes up at the pace the operation demands — even in difficult-to-reach locations.

Design

Can RBS design a solution for us?

Yes — tell us the outcome you need. We design formulations for your environment, building on knowledge and proven market experience over several decades.

Let us know how we can design solutions for you.

Stopping schedules, seal designs, heating histories or a stack that should be earning its keep — our mining team will answer with numbers, not brochures.

Contact the mining team